On this page we carry our STANDARD grade parking lot striping or warehouse marking tape in both Yellow and White, and in 2 inch wide and 4 inch wide rolls. Prices are $59.99 for our 2 inch rolls, and $79.99 for our 4 inch rolls – 150 feet long. This is an aluminum based product which means it has the ability to conform to any surface with the use of pressure applied to the tape. If properly conformed to the surface, the tape will give a long service life.
Our STANDARD 4″ x 150′ and 2″ x 150′ pavement and warehouse floor marking tape rolls are designed to stripe asphalt & cured concrete surfaces, parking lots, parking garages, cement warehouse floors, industrial factory floors, streets and any other area where vivid delineation is desired. Aluminum or Foil Backed pavement marking tape is simple to install with no special equipment or contractor needed. This product is as thick as normal parking lot paint with the addition of a mild reflective surface which makes the stripes much more visible at night. Our pavement / floor tapes aggressive adhesive and conformable aluminum backing insure that when properly applied your reflective white or yellow lines will remain in place. (Note – Longevity depends on traffic flow and proper installation.)
To install our pavement or warehouse striping tape simply apply it to a clean, dry surface and press it on with a bouncy rubber tire like on a car or golf cart. A dolly (hand truck) can also be used with weight on it. Multiple passes over the tape may be needed depending on how rough the surface is and how much weight you are using to press the tape down. The outside temperature should be in excess of 50 degrees. Proper adhesion is achieved by going over the tape with a heavy rubber roller or by using your vehicle tire. This conforms the aluminum base tape to the surface and creates a seal which keeps dirt or water from getting beneath the tape. Sometimes several passes are necessary to conform the tape to the surface. When using a vehicle be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. It is best to apply when it has not rained in 48 hours . After application the tape is ready for traffic. Full curing occurs after about 48 hours and it is best if it does not rain during this time. Dry, clean, sun warmed asphalt or cement is ideal. The tape will conform to a moderately rough surface but performs best on smooth surfaces. Parking lots or warehouses with moderate to light traffic often get years of service out of the tape.
For large projects we suggest you apply a roll first to determine whether this product will suit your needs. If you would like to test a piece of the tape I can mail a sample piece to you. Whether you obtain a sample or buy a roll to try, it is always recommended that you test a piece on your surface first to get up to speed on installation.
IMPORTANT – Our pavement marking tapes are not recommended for freshly sealcoated surfaces as the sealcoat will degrade the adhesive. Sand, dirt, oil, sealcoat or fresh curing paint can also prevent this product from properly adhering.
